Общие сведения
Название:Hydraulic Bending Machine (WC67Y 125T250
Модель:WC67Y 125T2500
Тип:Гибочный станок
Product Description

* Steel-welded frame, vibration to eliminate stress, with high strength and good rigidity.
* Hydraulic top-drive, steadiness and reliability.
* Mechanical stop, steel torsion bar to maintain synchronization, with high precision.
* Motorized-adjusting device of backgauge and RAM's stroke, fine adjusting by handwheel, numerical display.
* The main sliding pairs such as oil cylinders, piston rods, guide ways etc. Are all treated with wear-resisting measures.
* Deflection compensation unit installed on the top die. Manual crowned bottom die holder is adopted for the machine above 4000mm.
* Travel limit protection and foot pedestal mounted emergency off switch. Full machine guarding with safety interlocker that is set in the electric box by automatic cutting off main power when the box door is opened. Protecting barrier with safety interlocker is mounted on the back of the machine.

Optional:
* Sectional tooling with different lengths may store forming a certain length to bend the closed frame workpiece.
* The adjusted value of the RAM and the backgauge can be displayed by digital readout (electronic displays).
* Side & rear protection fence with interlock
* Photo-electricity protection (Infra-red light sensor to monitor load area).
* Any tailor-made are available on the request.

NO.
 
Item
 
Parameter value
 
Unit
 
Remark
 
1
 
Nominal force
 
125 0
 
KN
 

 
2
 
Bending width
 
25 00
 
mm
 

 
3
 
Slider travel
 
120
 
mm
 

 
4
 
Max opening height
 
360
 
mm
 

 
5
 
Distance between vertical poles
 
1900
 
mm
 

 
6
 
Depth of throat
 
300
 
mm
 

 
7
 
Travel times
 
8
 
Time / min
 

 
8
 
Axial plunger pump
 
25 MCY14-1B
 

 
9
 
Max force of system
 
22
 
Mpa
 

 
10
 
Motor power
 
11
 
Kw
 

 

Сайт поставщика: madeinchina.com

Наши услуги:

  • восстановление изношенных деталей;
  • цветной и нержавеющий прокат со склада в Ростове-на-Дону;
  • механическая обработка металлов( токарные и фрезерные работы);
  • изготовление валов,валков,подшипников скольжения,втулок(баббитовых,бронзовых,латунных,фторопластовых) и др. деталей по вашим чертежам или изделиям.
"Российское станкостроение" 2000-2011. Россия, г.Ростов-на-Дону ул.Орская 9 тел.(863) 290 88 31, 290 88 30, г.Москва ул. Яна Райниса 18
Продажа б/у станков в Ростове
Rambler's Top100 рейтинг@Mail.ru